I have just finished homebrewing a 4-way switched K9AY loop. I used an old
Heathkit cable-less antenna switch, model HD-1481, as the controller. On
the antenna end I used Gary's circuit except for switching to 24 volt
relays and using a binocular transformer instead of the trifilat
autotransformer in the original design.
The problem is that I have serious hum modulation in each of the powered
positions of the direction switch (+/- 24 DC and 24 AC). The antenna shows
good directivity, so I'm fairly sure the basic circuit is wired correctly,
and the relay switching is working.
To isolate the receiving antenna from the 24 volts, the HD-1481 relay box
uses a 1 MH RF choke and .02 uf blocking capacitors. The original K9AY
design just uses .01 capacitors at the antenna end. Should I plan on
adding a similar RF choke at the antenna unit, or is there someplace else I
should be looking for the problem.
73, Pete N4ZR
The World HF Contest Station Database
Full details on 3300 contest stations
Updated 5/5/07 http://www.pvrc.org/WCSD/WCSDsearch.htm
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|