Years ago when I did in my MFJ meter, 50 ohms was reading 40 ohms. It was a
real chore to change out the bad diode and calibrate.
73
Bruce-K1FZ
www.qsl.net/k1fz/pennantnotes.html
----- Original Message -----
From: "Pete Smith N4ZR" <n4zr@contesting.com>
To: "topband reflector" <Topband@contesting.com>
Sent: Friday, January 24, 2014 9:57 AM
Subject: Topband: End of a bias tee adventure?
After making all of the recommended changes, I hooked up my MFJ and got
>650 readings regardless. When connected to a 75 ohm dummy load, it
reads completely normally, as does shorting the input (R=0_ If I had
managed to damage the MFJ with DC voltage on the input, would you expect
no readings at all (>650 everywhere)?
--
73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|