Jim,
If I remember correctly placing an additional transmitting type cap across the
units load cap did the job. Don't remember the value I used. My guess 100 or
200 PF. I used a cap I had in the junk box. You will need to remove the cap in
most cases for the other bands.
Rich AA2MF
Sent from my iPad
> On Dec 17, 2015, at 01:17, Jim Murray via Topband <topband@contesting.com>
> wrote:
>
> Anybody know how to make an SB-1000 tune properly on 160? Ok on other bands
> but doesn't like 160, dummy load or well tuned Inv.L. Is it a quirk of the
> amp needing a modification or possibly a bad component? Saw nothing obvious
> before putting it to use but have not had the cover off since.Thanks,Jimk2hn
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|