Hello everyone,
I hope that this is an appropriate question for this
reflector.
I want to start building my ground panel outside where
all my coax cables will enter the house. I had
planned on using a copper sheet perhaps 24" x 24"
mounted on 1/4" plywood to hold all of my lightning
protection.
I had also thought of mounting this in a water tight
box, but do not know if this is appropriate or what
type of box should be used. Also should this be tied
in with the ground where the power enters into the
house or should it remain separate? Most importantly,
am I on the right track? I want to get this right the
first time.
TIA
Nate
N8RIT
__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|