Hi Nate; you might review what polyphaser co has to offer on
www.polyphaser.com.
K7MAX
----- Original Message -----
From: "Nathaniel Gates" <n8rit@yahoo.com>
To: "towertalk" <towertalk@contesting.com>
Sent: Wednesday, August 29, 2001 8:29 AM
Subject: [TowerTalk] Single Point Ground
>
> Hello everyone,
>
> I hope that this is an appropriate question for this
> reflector.
>
> I want to start building my ground panel outside where
> all my coax cables will enter the house. I had
> planned on using a copper sheet perhaps 24" x 24"
> mounted on 1/4" plywood to hold all of my lightning
> protection.
>
> I had also thought of mounting this in a water tight
> box, but do not know if this is appropriate or what
> type of box should be used. Also should this be tied
> in with the ground where the power enters into the
> house or should it remain separate? Most importantly,
> am I on the right track? I want to get this right the
> first time.
>
> TIA
>
> Nate
> N8RIT
>
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute with Yahoo! Messenger
> http://phonecard.yahoo.com/
>
> List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
> Trylon Titan towers, coax, hardline and more. Also check out our self
> supporting towers up to 96 feet for under $1500!!
http://www.anwireless.com
>
> -----
> FAQ on WWW: http://www.contesting.com/FAQ/towertalk
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
>
>
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|