John:
This is a good post from an experienced person. ALL good points. Thank you,
Chris opr VE7HCB
At 07:21 AM 2002-07-22 -0500, W0UN--John Brosnahan wrote:
>Hi, Mark--
>
>Don't know about exploding grinding wheels--but using them on aluminum
>ruins them. Fills up the pores with aluminum and they won't work on anything
>after that. You can use a diamond dressing tool to clean them up--with a
>corresponding reduction in diameter.
>
>There are cutoff saws that are similar to miter saws--but usually the cutoff
>saw only has one degree of "freedom" and is usually used with a "grinding"
>type blade for cutting steel. The miter saws can have have up to four
>degrees
>of freedom (if you include the newer saws with travel slides). These usually
>have regular toothed blades and carbide tipped blades can be used on
>aluminum. Both types of saws have clamps for holding the work piece.
>
>I have both types and often use the miter saw for aluminum when using the
>proper blade. The key with any carbide-tipped tooth blade on aluminum is to
>use a lubricant to keep the aluminum from building up on the teeth. There are
>special cutting fluids/sticks for aluminum but almost anything is better than
>nothing (except for things like Tri-chloro-ethane). A wax candle or a bar
>of soap
>should be used at a minimum. Otherwise you will get a buildup of aluminum
>on the blade and it will be deposited on the work piece making a less than
>ideal
>cut and it will also need to be cleaned from the blade--not an easy task.
>Best bet is to use the proper cutting fluid on the work or apply a stick type
>lube to the blade.
>
>I usually use the cut-off/miter type saws for tubing and angle or channel
>aluminum. For larger plates I use my 12 inch table saw or my 12 inch
>radial arm saw. Go very slowly, use the proper cutting fluid, and wear ear
>and eye protection. Aluminum sawing gets LOUD. If using a fine-toothed
>carbide-tipped blade, expect to pay $100-$150 for the blade for a larger
>(12 inch plus) diameter. An investment worth protecting by using the
>proper cutting fluids.
>
>Besides eye protection it is considered good form not to stand in line with
>the blade when cutting in case any carbide teeth should break loose.
>
>--John W0UN
>
>_______________________________________________
>Self Supporting Towers, Wireless Weather Stations, see web site:
>http://www.mscomputer.com
>Call 888-333-9041 to place your order, mention you saw this ad and take an
>additional 5 percent off
>any weather station price.
>_______________________________________________
>Towertalk mailing list
>Towertalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
|