I recently decided to rebuild my rotator with has the Pro-search digital
interface. It had not been used in about 10 years. I replaced all the
ball bearings as well as installing a Rotordoc quick connect fitting on
the unit. I believe I got the 8 lugs wired back up correctly. The
color codes that came with the Rotordoc connector instructions did not
match the colors of my rotator and I failed to notice this before I had
disconnected the wires from the terminal. The rotator rotates fine but
there is no indication of movement on the digital readout. When the
unit is first turned on it shows 000 but after the break is released it
shows 666 and does not changed while the rotator is turning.
Any ideas?
--
73,
Tom <KQ5S@ARRL.NET>
|