I have heard the use of duckseal to work on old worn out forms but I am not
sure how safe this is.
Tom
----- Original Message -----
From: <[email protected]>
To: "Jerry Keller" <[email protected]>
Cc: "(Reflector) TowerTalk" <[email protected]>
Sent: Wednesday, September 24, 2003 3:46 PM
Subject: Re: [TowerTalk] Cadweld, Ultraweld, etc
k my memory. You also don't
> need to buy every different mold for all the applications you listed. For
> example, you can use the one in and one out for a single wire terminating
at
> the rod by simply stuffing a small stub of wire into the other opening and
then
> use the weld. You can also do the same for the two in and two out by
again
> sticking a short stub of wire into the unused openings. You want to fill
these
> up with something so the molten metal does not leak out. QSL?
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|