To: | Tom Rauch <w8ji@contesting.com>, <towertalk@contesting.com>,"Pete Smith" <n4zr@contesting.com> |
---|---|
Subject: | Re: [TowerTalk] Shack wiring |
From: | Jim Lux <jimlux@earthlink.net> |
Date: | Mon, 24 Jan 2005 09:57:18 -0800 |
List-post: | <mailto:towertalk@contesting.com> |
At 08:06 AM 1/24/2005, Tom Rauch wrote:
> My entire shack is on a single 110V circuit (separate 220 for the > amplifier). That's the difference between "service voltage" and "utilization voltage". You'll find, for instance, that there are 240V and 480V three phase services, but you'll only be able to buy 230V or 460V three phase motors. The difference is in the "allowance" for voltage drop in power distribution from service entrance to point of use (2% for NEC) Wow. I would guess a typical HF radio might draw an amp or less from the mains on receive. That would mean you have an ESR of .2 ohms in the mains. That's pretty bad. If you use the NEC 2% drop guideline, and assume 120V service, that's 2.4V drop.. a 15A circuit could have 0.16 Ohms series resistance. That's not too far from 0.2 Ohms.. Just ballparking here.. AWG14 copper (which is what most houses are wired with) is 2.5 ohms/1000 ft. To get to 0.16 ohms, you only need 64 feet. There's two conductors, so if you're more than 32 feet from the panel, you've got 0.16 ohms in series (not even counting the resistance of the connections, switches, circuit breakers, receptacle/plug combination along the way). Remember that the NEC (which drives most wiring requirements) is really only concerned with burning down the house (it IS published by the National Fire Protection Association, after all)... As long as the voltage drop isn't all in one place, they're not too concerned with "good regulation" at the load. Also bear in mind that the 2% is a guideline... Good practice on load design is that it should accept 10% variation around the nominal input voltage, just for such reasons. Interestingly, noticeable light blink doesn't take a very big voltage change (<0.5 volt, in my fuzzy recollection) Jim Lux, W6RMK _______________________________________________ See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA. _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TowerTalk] Utility pole beam mount, Randy Frazer |
---|---|
Next by Date: | Re: [TowerTalk] Utility pole beam mount, Mark - AA6DX |
Previous by Thread: | Re: [TowerTalk] Shack wiring, Tom Rauch |
Next by Thread: | RE: [TowerTalk] Shack wiring, Keith Dutson |
Indexes: | [Date] [Thread] [Top] [All Lists] |