Towertalk
[Top] [All Lists]

Re: [TowerTalk] EZ-Way tower information

To: "Lance" <jlhoffman@alltel.net>,"towertalk" <towertalk@contesting.com>
Subject: Re: [TowerTalk] EZ-Way tower information
From: "Harry Brown" <harryhbrown@earthlink.net>
Date: Tue, 28 Nov 2006 11:01:30 -0500
List-post: <mailto:towertalk@contesting.com>
I've got an EZ Way catalog CHB with no date on it but likely from the 60's.

It does not give many details but it says the RBS-50 will "support a 3
element triband antenna in winds up to 60 mph without guys. If a larger beam
is used, the tower should be guyed!"

In a table it says "it will support, without guys a 3 element mini or 4
element triband antenna in winds up to 60 mph or  a 3 element 20 meter full
beam or a 6 element triband antenna with a 50 mph wind"

That's not "technical " information but it's all I have.

73, Harry, W3IIT

----- Original Message ----- 
From: "Lance" <jlhoffman@alltel.net>
To: "towertalk" <towertalk@contesting.com>
Sent: Tuesday, November 28, 2006 10:33 AM
Subject: [TowerTalk] EZ-Way tower information


About a year ago, I acquired a crank-up, tilt-over
tower.  Just recently found out what it is and got
a manual off "bama".

It's an EZ-Way RBS-50.  It's in good shape, but
when removing it, the "WonderPost" had to be
cut off, a foot below the surface.  I have welded
an extension to the post.

My question is:  What is the capacity of this
tower?
I would like to put a 2-element 40-meter yagi on
it.
Something like a Cushcraft, or HyGain.  Would
they exceed the load limits?

What is the capacity of this tower?

Thanks for any information!

73, Lance WN0L


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>