ORIGINAL MESSAGE:
On Thu, 30 Nov 2006 21:28:15 -0800, "Tom Osborne" <w7why@verizon.net>
wrote:
>Hi Bill
>
>There are lock nuts and bolts that have holes in the end of the bolt for a
>cotter pin or some other type of pin to go through. Kinda like the nut on
>your wheel bearings. 73
>Tom W7WHY
------------ REPLY FOLLOWS ------------
Ok, but same question I posed earlier: One of the nuts has a reverse
thread. Where do you get such a nut?
I suspect that threading the guy wire through the turnbuckle is the
easiest and best method.
Bill, W6WRT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|