Drax
There is a lot of information around and here you receive a good info but if
you have a doubt of your knot , always will trust in a clamp above the knot to
stop it to slip over the mast
safety is the best, for my is no problem if take 2 minutes to remove it from
the mast.
Hector Garcia XE2K / XF1K
Mexicali B.C DM22fp
P.O.Box 73
El Centro CA 92244-0073
USA
http://www.xe2k.net
http://www.dxxe.org
--- On Mon, 12/29/08, Drax Felton <draxfelton@gmail.com> wrote:
From: Drax Felton <draxfelton@gmail.com>
Subject: [TowerTalk] Knot tying
To: towertalk@contesting.com
Date: Monday, December 29, 2008, 5:19 PM
Does anyone know what knot would be best for lifting a mast pipe up and into
the rotor using a gin pole?
I need something that won't let the pipe slip through, but I also don't
want
a hole, or something difficult to untie.
KB3X
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|