Jerry,
Thanks for the suggestion - I certainly hadn't across that particular
configuration option.
But sad to say it has made no difference: 10%, 1% 0.001% I still get the
same gross error!
Steve G3TXQ
K4SAV wrote:
> Steve
>
> I have also seen cases where EZNEC will not repeat the results of a
> calculation after reopening a file and re-running it. It's sometimes
> frusterating when you are preparing some data, need one more piece of
> data, rerun the file and everything changes. I always thought it was
> because EZNEC was changing the data it was using for the ground model.
> It stores that data and doesn't necessarily recalculate it every time,
> and I thought it was just making a different decision about which
> ground-data file to use. Usually when it does this, the answer is only
> different by tenths of a db, however in your case, seems it was making a
> really gross error. Check your setting for "ground file tolerance".
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|