The Rohn design assumes one 5/8" diameter line on each tower face.
The wind rating is higher for ham tower installations where only a few RG-213
coax cables and small diameter control lines are fastened to the legs (not the
face) of the tower.
73
Frank
W3LPL
>On 8/18/2009 9:31 PM, K7LXC@aol.com wrote:
>> Howdy, TowerTalkians --
>>
>> This thread contained lots of anecdotal information and I found it
>> surprising that NO ONE mentioned what the tower spec from the manufacturer
>> is.
>>
>> Sixty feet of 25G (I think that was the height of interest) is rated
>> for 16.9 square feet @ 70 MPH, 10.2 sq.ft. @ 90 MPH and 8.2 sq.ft. @ 110
>> MPH. In any case it looks like you're covered.
>>
>> In the future, _www.rohnnet.com_ (http://www.rohnnet.com) has an
>> online catalog with these specs. And as always, follow the LXC Prime
>> Directive
>> to "DO what the manufacturer says."
>>
>> Cheers,
>> Steve K7LXC
>> TOWER TECH
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|