Towertalk
[Top] [All Lists]

Re: [TowerTalk] Stripping LMR-600

To: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Subject: Re: [TowerTalk] Stripping LMR-600
From: Scott Reed <sreed@nwwnet.net>
Reply-to: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Wed, 21 Apr 2010 08:08:28 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I use the LMR600 strip tool from Tessco.

Tommy Alderman wrote:
>  
>
> What is the recommended tool for stripping LMR-600 for a type-N connector?
> Do most of you use just a sharp blade and careful measurements or do you
> recommend the purchase of a stripping tool? If you use a stripping tool, can
> you give me a model number and a source please? I'm going to be doing a
> limited quantity of less than ten connectors.
>
>  
>
> Thanks for any information.
>
>  
>
> Tom - W4BQF
>
>  
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>   

-- 
Scott Reed
Owner
NewWays Networking, LLC
Wireless Networking
Network Design, Installation and Administration
Mikrotik Advanced Certified
www.nwwnet.net
(765) 855-1060


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>