Towertalk
[Top] [All Lists]

Re: [TowerTalk] Stripping LMR-600

To: "'Tower and HF antenna construction topics.'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Stripping LMR-600
From: "W0MU Mike Fatchett" <w0mu@w0mu.com>
Reply-to: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Wed, 21 Apr 2010 11:58:38 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I use a stripping tool.  They are great!
 


CC Packet Cluster W0MU-1
W0MU.NET or  67.40.148.194

"A slip of the foot you may soon recover, but a slip of the tongue you may
never get over." Ben Franklin 



-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Tommy Alderman
Sent: Wednesday, April 21, 2010 4:57 AM
To: 'Tower and HF antenna construction topics.'
Subject: [TowerTalk] Stripping LMR-600

 

What is the recommended tool for stripping LMR-600 for a type-N connector?
Do most of you use just a sharp blade and careful measurements or do you
recommend the purchase of a stripping tool? If you use a stripping tool, can
you give me a model number and a source please? I'm going to be doing a
limited quantity of less than ten connectors.

 

Thanks for any information.

 

Tom - W4BQF

 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>