Towertalk
[Top] [All Lists]

Re: [TowerTalk] OR2800 rotor cable

To: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Subject: Re: [TowerTalk] OR2800 rotor cable
From: "Jim Nail" <james.nail@att.net>
Reply-to: james.nail@att.net, "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Thu, 22 Apr 2010 16:55:14 +0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I installed my new OR2800 with 100 feet of the cable from the Wireman last 
fall.  I use Jeffs GH controller generating the commands from N1MM to turn the 
rotator. No noise and no missing pulse data! Works flawlessly.
Jim WA2MBP
Sent via BlackBerry by AT&T

-----Original Message-----
From: "Al Williams" <alwilliams@olywa.net>
Date: Thu, 22 Apr 2010 08:48:40 
To: Tower and HF antenna construction topics.<towertalk@contesting.com>
Subject: Re: [TowerTalk] OR2800 rotor cable

I wasn't aware that the Green Heron controller could be used to turn the 
OR2800 rotator!

k7puc


----- Original Message ----- 
From: "Les Kalmus" <w2lk@bk-lk.com>
To: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Sent: Thursday, April 22, 2010 8:32 AM
Subject: Re: [TowerTalk] OR2800 rotor cable


> One leg of the circuit is grounded, which would be the shield if using 
> coax.
> I did not have the noise problem using unshielded multi conductor cable
> until my controller failed and M2 "upgraded" it to the current version.
> Without going into the details, none of the fixes they sent me helped.
> Some people have reported that the noise is not a problem when using
> coax (i.e., W3LPL).
> Rather than running another wire, I switched to a Green Heron controller
> which makes no noise using the original cable.
>
> Les W2LK
>
> Jim Brown wrote:
>> On Thu, 22 Apr 2010 10:49:59 -0400, Les Kalmus wrote:
>>
>>
>>> These pulses are a notorious source of noise when the rotator is in 
>>> motion.
>>> M2 recommends shielded cable, i.e. RG-58 to suppress that noise.
>>>
>>
>> Interesting. That's very different from shielded twisted pair. Question: 
>> Is
>> the circuit ground-referenced? If so, RG58 is probably the best solution. 
>> If
>> it's balanced, a good twisted pair should work as well.
>>
>> 73,
>>
>> Jim K9YC
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>