Most mounting plates for CDR/Hy-Gain rotators have 6 holes. Be careful in
drilling them.
73 Dave K4JRB
----- Original Message -----
From: "Ed G" <ed.goss@comcast.net>
To: <towertalk@contesting.com>
Sent: Thursday, December 23, 2010 8:19 PM
Subject: [TowerTalk] Tailtwister T2X Rotator/Mast Mount
> Hi Folks,
> I notice the T2X rotator has six mounting holes on the base, but the
> lower mast mount I will be using (the heavy duty one) only has four holes.
> It seems like using all six mounting bolts would give me better wind load
> margin, so I'm thinking about drilling two more holes in the lower mast
> mount so I can use all six bolts. Has anyone else ever done this?
> --Ed--
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|