Towertalk
[Top] [All Lists]

[TowerTalk] Aluminum clad wire

To: towertalk@contesting.com
Subject: [TowerTalk] Aluminum clad wire
From: Grant Saviers <grants2@pacbell.net>
Date: Wed, 29 Dec 2010 23:14:10 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I've been looking for aluminum clad steel wire for an antenna project 
and this led finally to a source for aluminum clad high tensile steel 
($90 for 3000'  11 ga).  Certainly a LOT cheaper than copper or 
copperweld alternatives.

http://www.kencove.com/fence/Aluminum+Clad+Wire+11-11.5+Gauge_detail_WAC11.php

It took quite a bit of googling to find this, but now the question is 
why not use this for all wire antennas because it is cheap, very 
strong,  low-stretch, and corrosion resistant, although a little hard to 
bend.  One spool would make a lot of really tough through the woods 
Beveridges!  Also, there a number of horse fencing products that could 
be useful for wire antennas.

There are some assumptions with this farm supplier, i.e. Al thickness is 
good enough for RF.  I found makers of well specified (ASTM B-415 
Hard-Drawn Aluminum-Clad Steel Wire) Al clad guy, ground, and shield 
wires for electric power distribution but the sizes and quantities per 
spool are rather large and I couldn't find any retail sources.  One tm 
is Alumoweld.

Anybody know of sources for Al clad steel wire suitable for antenna use?

Grant
KZ1W



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>