+1 on buyheatshrink.com. I've purchased thousands of dollars worth of
shrink tube from them (for commercial installs) and have been happy with
the quality, service, and value - their tubing runs about half of what
3M costs. For connectors I buy the 3 to 1 "dual wall" medium wall black.
The "dual wall" refers to the adhesive lining.
-Steve K8LX
On 3/10/2011 12:06 PM, Bill Winkis wrote:
> Here you go ....
>
> http://www.buyheatshrink.com/heatshrinktubing/index.htm
>
> Been using this stuff for over 10- years and have had ZERO failure....I
> use the "UV/adhesive Type" ..and seal the ends with "Loctite Epoxy
> Repair Putty....
> About 2 inches from the join (Connector or...??) I make a bead of the
> epoxy around the wire/co-ax ... then slide the tubing over the epoxy the
> connector and the epoxy ...then nead the tubing into the epoxy on both
> ends..then heat gun shrink!!!
>
> -Bill
> http://www.kc4pe.com/amateurshack.htm
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|