Six wires are used on the G2800
The controller is a 6 pin plug, and the rotor has a 7 pin plug, where pin 7
is not used...
Mike
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Mike Ryan
Sent: Thursday, March 31, 2011 8:45 AM
To: 'towertalk towertalk'
Subject: Re: [TowerTalk] answers tnx Yaesu 2800
Charles, In case it was not covered here, I think - I THINK the 2800 uses an
additional wire of the control cable. My 1000DXA rotor uses a 6 wire cable I
am pretty sure. I used to have a 2800 and I think it used 6 wires...perhaps
someone can shed some light on that, this again if it has not already been
discussed.
-Mike
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6002 (20110331) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|