I got some of those steel rods that are used to keep insulation up under the
house. I can make around 300 8 inch pins for $10. Right now I have the
time and not the money
Mark N1UK
----- Original Message -----
From: <n8de@thepoint.net>
To: "WA8JXM" <wa8jxm@gmail.com>
Cc: <towertalk@contesting.com>
Sent: Sunday, 03 July, 2011 12:06 PM
Subject: Re: [TowerTalk] Next Radial - Question
> Why not use galvanized pins? Use insulated wire and the galvanic
> action you're considering is moot.
> 73
> Don
> N8DE
>
>
> Quoting WA8JXM <wa8jxm@gmail.com>:
>
>> I would not use galvanized pins for holding down copper wire. Cut
>> some stiff copper wire (such as #10 or #8) and use that for the hold
>> downs.
>>
>> Ken
>>
>> On Jul 3, 2011, at 10:34 AM, Tim Duffy K3LR wrote:
>>
>>> held down by galvanized landscape pins and at
>>> the end of each wire wrap around a pin pushed deep.
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|