On 7/20/2011 8:42 PM, David Jordan wrote:
> Still talking about this one... just pulled two 1/2" LDF4, 1/2" rotor cable,
> multi-mode fiber through 150ft of 4" conduit. A half a quart of lub made it
> a one man job that took ten minutes. I used sweeps on the ends but
> unfortunately had to use a 45 at two different places,
I use a pair of sweep 45's in place on each single sweep 90 as they make
the turn even less abrupt.
73
Roger (K8RI)
> so the conduit was
> zig-zagged and still the pull was easy. I'm sold on this stuff and an easy
> clean-up when done.
>
> 73,
> Dave
> wa3gin
> ----- Original Message -----
> From:<john@kk9a.com>
> To:<TOWERTALK@contesting.com>
> Sent: Wednesday, July 20, 2011 8:23 PM
> Subject: Re: [TowerTalk] pull lubricant
>
>
>> Once I pulled 1/2 hardline ...
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|