On 7/10/13 4:19 AM, Jim Brown wrote:
On 7/9/2013 6:40 AM, Pete Smith N4ZR wrote:
Sure, but the network cables were connected directly to the computer
motherboards. I have also lost a couple of RS-232 ports on my K3,
which now has a DB-9 surge protector on it - I'm inclined to think
it's a design problem.
YES. Cable shields MUST be bonded to the SHIELDING ENCLOSURE (the
chassis) at each end. If there is no shield, the signal return must be
<snip about the evils of indiscriminate use of shunt mode transient
voltage suppression>
There's a lot about these issues on my website. http://k9yc.com/publish.htm
Standler's book also covers this in quite some detail, along with
suggested designs.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|