Towertalk
[Top] [All Lists]

Re: [TowerTalk] TowerTalk Digest, Vol 136, Issue 10

To: towertalk@contesting.com
Subject: Re: [TowerTalk] TowerTalk Digest, Vol 136, Issue 10
From: john@kk9a.com
Date: Fri, 4 Apr 2014 14:11:30 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
One common problem with Yaesu rotators is water in the connector boot.  I
would check this connection first.

John KK9A


To:     towertalk@contesting.com
Subject:         Re: [TowerTalk] TowerTalk Digest, Vol 136, Issue 10
From:    ftravanty <W9JCC@wi.rr.com>
Date:    Fri, 04 Apr 2014 11:48:49 -0500

I plan on taking my Yaesu G-2800SDX rotor down this summer to replace an
intermittent position feedback pot, that has been acting up for the last
three years. It's been in service for over 15 years with low usage. I
suspect moisture possibly thaw &freezing in the winter. Couple of
questions. Anyone have any pot failure history with the G-2800 series
rotor? Anyone have factory setup instructions for re assembly , and is it
worth trying to shield the pot shaft bushing from water in this model
rotor,?
Thanks,
Frank W9JCC

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>