TU kindly for that information Bud ! Exactly what I was looking for. 73
Gedas, W8BYA
Gallery at http://w8bya.com
Light travels faster than sound....
This is why some people appear bright until you hear them speak.
----- Original Message -----
From: "W2RU - Bud Hippisley" <W2RU@frontiernet.net>
To: "Gedas" <w8bya@mchsi.com>
Cc: <towertalk@contesting.com>
Sent: Monday, July 07, 2014 1:31 PM
Subject: Re: [TowerTalk] Hy-Gain Calibration Pot/Switch
Push the switch in and adjust the pot until you have set the pointer to
exactly full scale. Then carefully push the switch in again to take the
circuit out of Calibration mode; now you should see your actual beam
heading — as accurately as it can be read. The Calibration switch
compensates for individual line voltages, circuit variables, etc. I used
the word “carefully” above because it’s all to easy to impart a slight
rotation to the knob (and hence the calibration setting) when pushing on the
switch that’s on the same shaft.
Bud, W2RU
On Jul 7, 2014, at 12:38 09PM, Gedas <w8bya@mchsi.com> wrote:
I found in my collection a Hy-Gain rotor control box that has a push/pull
switch on the calibrate pot. None of the manuals for my TT and Ham-4
rotors mention that switch. Can someone explain how the switch is to be
used or point me to a URL for the manual that would? Tnx
Gedas, W8BYA
Gallery at http://w8bya.com
Light travels faster than sound....
This is why some people appear bright until you hear them speak.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|