Towertalk
[Top] [All Lists]

Re: [TowerTalk] Over heated cores

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Over heated cores
From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
Date: Thu, 03 Jul 2014 22:57:49 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 7/3/2014 6:07 PM, larryjspammenot@teleport.com wrote:
Are these new ones that you're talking about the #31 mix material? Where are 
you finding them for $5/each?

Yes, they were new #31 mix. I purchased a 100 about 2 years ago and that was roughly $5., but close. I'd need to find the paperwork to even know where I purchased them after 2 years.

73

Roger (K8RI)

LJ


-----Original Message-----
From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
Sent: Jul 1, 2014 5:25 PM
To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Over heated cores

I have several 2.4" OD cored. Will overheating cause their properties to
change after they cool down  I have 2 out of an AV640 that now have a
dull surface. I have quite a few new ones, so replacing them is not a
problem, but at near $5 each I'd like to save them if they are any
good.  The material is nor cracked/fractured.

73

Roger (K8RI)

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>