Yes, the voltage maxima are coincident with the current minima, so
maximum dielectric loss will be coincident with minimum copper loss. How
much those two offset each will obviously depend on their relative
magnitudes.
As a numerical example: a 50 Ohm line with a 2:1 SWR will have maximum
voltage where the impedance is 100 Ohms resistive; that's also the point
of minimum current. A quarter-wave away from that point the impedance is
25 Ohms resistive - that's the point of minimum voltage/maximum current.
Steve G3TXQ
On 02/08/2014 23:22, Jim Lux wrote:
My off the cuff question was more along the lines of "are the current
maxima at the same place as the voltage maxima": that is, is max
dielectric dissipation going to occur at the same place as max copper
loss dissipation, or are they going to be, say, 90 degrees apart.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|