Towertalk
[Top] [All Lists]

Re: [TowerTalk] Cutting a FT-240 type 33...in half ??

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Cutting a FT-240 type 33...in half ??
From: EZ Rhino <EZRhino@fastmovers.biz>
Date: Tue, 10 Feb 2015 07:53:41 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Jim,

Try a tile saw, or brick saw.  If you don't have one, keep your toroid in your 
car and while you drive around, keep an eye open for construction crews laying 
brick.

Chris
KF7P






On Feb 9, 2015, at 22:55 , Jim Thomson wrote:

Ok, I have a requirement where an additional  one or two x  2.4 inch OD, type 
33 cores needs  to be added to  an existing choke balun.
Since each end of the RG-393 silver plated + teflon coax is already silver 
soldered to a 7-16 DIN connector  at each end of the nema box,
I would rather not have to take the entire assy apart.  Major pita.    393 coax 
has TWO  silver plated braids, and in this case, each of the braids has been 
carefully
separated at each end, and each braid is silver soldered to a lug,  that is 
bolted to  the 7-16 din connector flange, via the SS  8-32 machine screws.
IE: 2 of the 4 corners of each 7-16 din female coax connector gets a braid 
attachment.

Can a 2.4 inch OD, 1.4 inch ID, type 33 toroid  be cut in half, edges sanded,  
then  placed around the existing  4-5 turns of 393 coax, then
held together via glue, ty-raps, both, or some other method ???   I have an 
excellent H-V bandsaw, made for cutting steel, hard steel, and AL.
IE: 80-120-200 ft per minute.   It would slice through a toroid very quickly.   
If what I propose is feasible, it would save me a lot of grief. 
I already checked, and the big, type 43 snap on types  will not fit, since they 
only have a 1 inch ID. 

Tnx...... Jim   VE7RF



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>