Towertalk
[Top] [All Lists]

Re: [TowerTalk] Zerk fitting for MA-40

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Zerk fitting for MA-40
From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
Date: Fri, 10 Apr 2015 13:03:52 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
All Zerks I have seen were either 1/8th inch, or 1/4 inch pipe thread, or something that looked like a very coarse tapered strange pipe thread on farm machinery, industry, and ham equipment over many years.

73

Roger  (K8RI)

On 4/10/2015 12:26 PM, Kurt Cathcart. KR2C wrote:
Good information everybody.  And quick too!  Thank you.

One more question. Removing the remains of the Zeck fitting, would anybody know if this is tapped or pressed?

-Kurt
KR2C


On 4/10/2015 11:59 AM, Kurt Cathcart. KR2C wrote:
I have a US Tower MA-40 with the rotator base. The last time I greased the bearing, the Zerk fitting broke when I was removing the grease gun. Does anybody have an idea of what I should replace it with? I got crickets from US Tower.

-Kurt
KR2C

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


--

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>