Re: [TowerTalk] Zerk fitting for MA-40

[w6rgs@cox.net]

Kurt,
A phone call to US Tower would probably  get you a quick and accurate answer.
Bill W6RGS


At 09:26 AM 4/10/2015, Kurt Cathcart. KR2C wrote:
> Good information everybody.  And quick too!  Thank you.
>
> One more question.  Removing the remains of the Zerk fitting, would 
> anybody know if this is tapped or pressed?
> -Kurt
> KR2C
>
>
> On 4/10/2015 11:59 AM, Kurt Cathcart. KR2C wrote:
> > I have a US Tower MA-40 with the rotator base.  The last time I 
> > greased the bearing, the Zerk fitting broke when I was removing the 
> > grease gun.  Does anybody have an idea of what I should replace it 
> > with?  I got crickets from US Tower.
> > -Kurt
> > KR2C
> >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk