Re: [TowerTalk] Tower Build

[Bryan Swadener via TowerTalk <towertalk@contesting.com>]

My solution works for me, and was VERY easy and inexpensive to fabricate and 
use.
Since that is the case, I'm not going to change anything.

vy 73 es gl,
Bryan WA7PRC
http://www.tinyurl.com/wa7prc-tower

>Date: Fri, 3 Jul 2015 17:48:58 -0400
>From: Mike Reublin NF4L
>To: towertalk reflector
>Subject: Re: [TowerTalk] Tower Build
>
>Why do you say the tilt-plate wouldn't give you access to the vertical? The 
>Yagi's elements would be parallel to the ground, at whatever height you chose 
>to stop the descent, altho horizontal or below horizontal puts a lot of extra 
>stress on the raising gear. Even a few degrees above is significant. I stop 
>mine when the rotor is about eye level. I'm 5'10".
>
>73, Mike NF4L
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk