Thanks, John -
I'm not sure I can get the 2800 in the Hg-70HD.
73, Mike NF4L
> On Jul 21, 2015, at 12:08 PM, john@kk9a.com wrote:
>
> You probably should just replace it with a G-2800DXA.
>
> John KK9A
>
> To: towertalk reflector <towertalk@contesting.com>
> Subject: [TowerTalk] Rotor failure
> From: Mike Reublin NF4L <nf4l@comcast.net>
> Date: Tue, 21 Jul 2015 10:26:27 -0400
>
>
> The other day, I turned on my G-1000DXA and got no response. The box says 180
> degrees, and the antenna is pointed north.
>
> I read open on the wiper and pot wires, and on the motor pair. Applying
> 12v to
> the motor wires did nothing.
>
> I finally noticed the antennae were freewheeling in the wind. I lowered the
> tower and see no external signs of failure. Any speculation on what has
> failed
> and why? I'm wondering if the mast is centered. When the tower is horizontal,
> how does one tell?
>
> The antennas are a 4L Steppir w/30/40 and a 7L 6M beam. The vertical load is
> taken by a bearing. The "pin" bolt appears to be intact.
>
> 73, Mike NF4L
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|