I guess I would look at this like a coax or cable bundle.
Some individually label them, others stripe them, and I'm sure there are
other simple methods.
Sounds like a nice economic advantage if you don't mind two cables.
IMHO, you can always mark or stripe the 4-wire cables.
73 Mike K9MK/5
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Mike
Reublin NF4L
Sent: Tuesday, May 10, 2016 10:29 AM
To: taholmes160@gmail.com
Cc: towertalk reflector
Subject: Re: [TowerTalk] Rotor Control Cable
Keeping the color code straight would be tedious...
73, Mike NF4L
> On May 9, 2016, at 5:25 PM, Timothy A. Holmes <taholmes160@gmail.com>
wrote:
>
> Hi Guys - another one for the pile of questions
>
> I was looking through the DXE catalog the other night and noticed that 8
conductor rotor cable is .89 cents a foot, and 4 conductor is .29 cents a
foot. ASSUMING (and yes, I know the rules about assuming) Since I haven't
looked it up online YET, that the wire gauge is the same in both types of
cable, is there any hurt, harm or danger in using 2 runs of the 4 conductor
(total of about 60 dollars) vs 1 run of the 8 conductor (about 90 dollars)?
>
> I should note that I am currently using 2 runs of cable for the rotor and
it works great -- I want to do this "right" but I also want to be sensible
with my budget
>
> Thanks
> TIM
> W8TAH
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|