Towertalk
[Top] [All Lists]

Re: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor
From: Henk PA5KT <pa5kt@remijn.net>
Date: Mon, 21 Nov 2016 09:38:43 +0100
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
The G450XL uses an AC24V motor.

G800/1000 models are DC 24 V.

Not interchangeble.

Dont know if the G450A is the same as G450XL. I cannot find a schematic of the G450A.
If it uses 3 wires to control your motor it is AC.
2 wires it is DC.

73 Henk PA5KT

Op 11/17/2016 om 14:36 schreef Herbert Schoenbohm:
I have an orphan Yaesu G-8000DXA controller and would like to know if I can replace by G-450A control box with it without any modification? The plugs are the same and from the schematic the control circuit is similar. But I would like to know first before I brick the rotor on the tower. Please help.



Herb Schoenbohm, KV4FZ

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>