Towertalk
[Top] [All Lists]

Re: [TowerTalk] Yaesu G2800 DXA vs Yaesu G1000 in LM-470D Tower

To: <W1TR@YCCC.org>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Yaesu G2800 DXA vs Yaesu G1000 in LM-470D Tower
From: "K0DAN" <k0dan@comcast.net>
Date: Wed, 8 Feb 2017 15:02:05 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Yes it will, I have had all the Yaesu rotors on the same base plate in the top section of an LM470, they all fit. The G2800 is slightly taller so you may have to drop the mounting plate down a little further.

GL& 73

dan
k0dan

-----Original Message----- From: Terry G. Glagowski / W1TR
Sent: February 07, 2017 16:54
To: towertalk@contesting.com
Subject: [TowerTalk] Yaesu G2800 DXA vs Yaesu G1000 in LM-470D Tower

Does anyone know if a Yaesu G-2800 DXA will fit into the top section of an LM-470D motorized crank-up tilt-over tower where a Yaesu G-1000 DXA now is installed (dimensions)
?

73, Terry / W1TR  :  )


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>