Jamie,
They look different. The Tailtwister has 6 big bolts attaching the two
case halves. The Ham-M series (I II, III, IV) 4 has four small bolts.
HAM-IV
https://www.dxengineering.com/search/product-line/hy-gain-ham-iv-rotator-and-controller-combo-kits?autoview=SKU&keyword=HAM-IV&sortby=BestKeywordMatch&sortorder=Ascending
TAILTWISTER
https://www.dxengineering.com/search/product-line/hy-gain-t2x-tailtwister-series-ii-rotator-and-controller-combo-kits?autoview=SKU&keyword=Tailtwister&sortby=BestKeywordMatch&sortorder=Ascending
The Tailtwister is bigger, too, but if you only have one sitting in
front of you that is of relatively little value.
73 - Mark N5OT
On 8/14/2021 5:49 PM, WW3S wrote:
I have an older Hygain rotor, it has the brake wedge.....on the bottom
is stamped:
4244 (and then I think its a S with an X over it) and underneath the
part that X'd out is CS
and then on the bottom, off to the side, is 5 402
I thought it was a tailtwister....it definitely has a brake wedge
On Norms rotor service page it says you need to remove the bottom to
see the numbers.....does that mean split the case? Trying to avoid
having ball bearings going everywhere....I'd like to sell it, but
unsure whether its a 4 or a TT.....
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|