Well before K7NV became a SK, DX Engineering entered into an agreement with
Kurt to build the K7NV clamp.
Here is the three inch version:
https://www.dxengineering.com/parts/dxe-rtmc-3
Here is the two inch version:
https://www.dxengineering.com/parts/dxe-rtmc-2
73
Tim K3LR @ DX Engineering
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Steve
Dyer W1SRD via TowerTalk
Sent: Tuesday, November 8, 2022 2:07 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] More friction needed
Only a different mast clamp will help. The M2 clamp just does not have
enough contact area for demanding applications.
There might be a few K7NV mast clamps still available out there.
Maybe a longer wrench? :-)
73,
Steve
W1SRD
On 11/8/2022 10:00 AM, k7lxc--- via TowerTalk wrote:
> Howdy, TowerTalkians -
> I need more friction between an M2 mast clamp and the mast. How could I
> do that? What materials would work? Tnx. Cheers,Steve K7LXCCell:
> 206-890-4188
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|