I'd be curious to learn which crankup tower maker specifies, or even allows,
anchors to be used.
73 de Gene Smar AD3F
Sent from my Radio Shack TRS-80 model 100 laptop
On Tue, Jun 18, 2024 at 11:36 AM, john simmons<jasimmons@pinewooddata.com>
wrote: There are a ton of variables here. An engineer will hopefully chime in.
Variables:
* Guy wire angle
* Tower/antenna wind loading
* Wind speed area of USA
* Soil stability
* Height above ground for guy anchor point
* Safety factor
* Number of guy lines
* and etc
Many areas, even rural ones *REQUIRE* a PE-stamped engineering drawing for your
installation, plus a permit of some sort. I'd suggest looking at this point
before doing anything else. Sometimes the cost of fulfilling these requirements
is onerous and may preclude your project.
Some back of the envelope ideas:
* Don't use pipe! Square or round tubing has a much higher bend strength.
I-beam would be much better
* Remember the lever principle. The longer the length of the anchor steel
the stronger it is.
* Use concrete!!!
* Rent a power earth auger to dig the holes
* The anchor steel should be installed angled away from the tower
* Read the tower plans! They should give the load on each guy line and
that'll give you an idea what the bend strength of the anchor steel should be.
However since you are short-guying the load will be much higher
***Re-think your plan! Compromising tower installation is a very risky
business, especially when you consider what might happen should disaster occur.
Insurance companies.... lawyers...
73
-de "Curly" John NI0K
QRZ.com<https://www.qrz.com/db/ni0k>
Hamshack Hotline<https://hamshackhotline.com/> call me: 6100271
On 6/18/2024 9:33 AM, Kurt Cathcart, KR2C wrote:
Hello all
I'm planning an installation of a guyed 50' aluminum crank up tower. As per
the manufactured, they guy anchor point would be 40' from the tower. As per
the wife, this would be too intrusive into the yard.
My thought would to be using guy posts to anchor the guys to. The idea would be
create a foundation with a heavy pipe in the ground that would move the anchor
points closer to the tower. Would any of you have experience with this? If so,
what do I need to know going in? Bad idea?
-Kurt, KR2C
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com<mailto:TowerTalk@contesting.com>
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|