Because we had to.
Apparently you never grew up poor, or had a paper route or mowed lawns
to buy your ham equipment.
I'm sorry you never had to experience this. It makes one more wise about
money.
73, Jim W7RY
On 7/16/2024 4:05 PM, charlie@thegallos.com wrote:
As someone else said about all this,*WHY? * Even at the worst, most
expensive, they are $11.50. The minimum wage is $7.25, so what, 90 minutes
of work. I net you spend more in time and electricity to recycle the
connector.
This reminds me about the joke about how copper wire was invented, two hams
fighting over a penny
-----Original Message-----
From: TowerTalk<towertalk-bounces@contesting.com> On Behalf Of Arthur
Bernstein via TowerTalk
Sent: Tuesday, July 16, 2024 4:53 PM
To:towertalk@contesting.com
Subject: [TowerTalk] Recycling old PL-259 connectors.
This may sound caveman style, but I used to just cut of the connector with a
little bit of coax remaining. I'd unsolder the center pin and shake it out
then suspend the connector over a gas stove burner then with a pair of
pliers pull out the coax stub. If necessary clean out any melted
dielectric., heat again and shake out any remaining solder. Been doing this
for 60 years.ArtN2KA
Arthur Bernstein
n2ka@verizon.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
Thanks and 73, Jim W7RY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|