[TowerTalk] Recycling old PL-259 connectors.

[Arthur Bernstein via TowerTalk <towertalk@contesting.com>]

This may sound caveman style, but I used to just cut of the connector with a 
little bit of coax remaining. I'd unsolder the center pin and shake it out then 
suspend the connector over a gas stove burner then with a pair of pliers pull 
out the coax stub. If necessary clean out any melted dielectric., heat again 
and shake out any remaining solder. Been doing this for 60 years.ArtN2KA

Arthur Bernstein
n2ka@verizon.net
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk