I may have responded too soon.
I was referring to the tower guying size.
Steve
Sent from my mobile device
> On Sep 24, 2024, at 6:50 PM, Jim W7RY <jimw7ry@gmail.com> wrote:
>
> Yes. Tighten them all the way down. It really squishes the Phily down.
>
> Used 4000 lb Philly on a Rohn 25 without preform grips. Worked perfectly.
>
> 73
> Jim W7RY
>
>
>> On 9/24/2024 3:26 PM, RVZ via TowerTalk wrote:
>> Hi Guys,
>> Looking for advise on how to terminate Phillystran HPTG 1200I small
>> diameter 3/32" guy cable for maximum strength? Instructions say to use
>> 3/32" cable clamps and I've tried that but the small diameter Phillystran
>> squashes down so small the cable strength is greatly weakened. Perhaps I'm
>> tightening the cable clamps too tight? If so, there appears to be a real
>> fine balance between getting the clamps tight enough to hold but not too
>> tight to squash the cable and weaken it. Can anyone shed light on how to
>> properly tighten the cable clamps for maximum cable strength on this small
>> 3/32" diameter Phillystran? Thanks & 73! Dick- K9OM (RLVZ@aol.com)
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> --
> Thanks and 73, Jim W7RY
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|