I have seen on previous post where you can change the CommSlot setting in
Writelog.ini file, but when I look in my .ini file I do not find CommSlot1=1,
ComSlot=2, what I do have is shown below, so what one should I use to change
the Com setting for rig or CW? There are no CommSlot settings in my
Writelog.ini file. I would to make a change to ComSlot2=6.
[Ports]
COM1:=9600,n,8,1,x
COM2:=9600,n,8,1,x
COM3:=9600,n,8,1,x
COM4:=9600,n,8,1,x
LPT1=0x378
LPT2=0x0
LPT3=0x0
dvktype=2
dvkport=0
cwtype=2
cwport=1
dvkstoploop=1
dvkechomic=1
Comm1Used=USED,POLL,25
Comm1XmitControl=ALWAYS
Comm1RigManager={D0DE9422-0517-11D4-9D1B-00105AA43DDF}
CWPTTCONTROL=1
CWPTTDELAY=10
Comm2Used=CW,
Comm2RigManager={D0DE9422-0517-11D4-9D1B-00105AA43DDF}
Comm2XmitControl=ALWAYS
Tnx, Vince K6BIR
|