VinceK6BIR@aol.com wrote:
I have seen on previous post where you can change the CommSlot setting
in Writelog.ini file, but when I look in my .ini file I do not find
CommSlot1=1, ComSlot=2, what I do have is shown below, so what one
should I use to change the Com setting for rig or CW? There are no
CommSlot settings in my Writelog.ini file. I would to make a change
to ComSlot2=6.
-----------------------
Finally, a question I think I can answer. Just edit the .ini file and
add the lines you need, such as "Commslot2=6".
73
Ed
|