If they are not there, you can add them - Be careful typing - It's
CommSlot. Not ComSlot as you have once below. Here's mine:
[Ports]
COM1:=9600,n,8,1
COM2:=9600,n,8,1
COM3:=9600,n,8,1
COM4:=9600,n,8,1
CommSlot1=1
CommSlot2=4
CommSlot3=5
CommSlot4=6
> -----Original Message-----
> From: writelog-admin@contesting.com
> [mailto:writelog-admin@contesting.com] On Behalf Of VinceK6BIR@aol.com
> Sent: Sunday, February 17, 2002 8:03 PM
> To: writelog@contesting.com
> Subject: [WriteLog] CommSlot settings?
>
>
> I have seen on previous post where you can change the
> CommSlot setting in
> Writelog.ini file, but when I look in my .ini file I do not
> find CommSlot1=1,
> ComSlot=2, what I do have is shown below, so what one should
> I use to change
> the Com setting for rig or CW? There are no CommSlot settings in my
> Writelog.ini file. I would to make a change to ComSlot2=6.
>
> [Ports]
> COM1:=9600,n,8,1,x
> COM2:=9600,n,8,1,x
> COM3:=9600,n,8,1,x
> COM4:=9600,n,8,1,x
> LPT1=0x378
> LPT2=0x0
> LPT3=0x0
> dvktype=2
> dvkport=0
> cwtype=2
> cwport=1
> dvkstoploop=1
> dvkechomic=1
> Comm1Used=USED,POLL,25
> Comm1XmitControl=ALWAYS
> Comm1RigManager={D0DE9422-0517-11D4-9D1B-00105AA43DDF}
> CWPTTCONTROL=1
> CWPTTDELAY=10
> Comm2Used=CW, Comm2RigManager={D0DE9422-0517-11D4-9D1B-00105AA43DDF}
> Comm2XmitControl=ALWAYS
>
>
> Tnx, Vince K6BIR _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
|