Pete,
Same here on automatic fill in of Name/QTH of previous QSO. Wasn't
much of problem; just clicked on the Name & QTH and it appeared in the right
spots just as advertised.
Tom Webb, WA9AFM/5
----- Original Message -----
From: "Pete Stafford" <pete@staffordsystems.com>
To: <writelog@contesting.com>
Sent: Sunday, March 09, 2003 1:41 PM
Subject: [WriteLog] Sprint Module
> A few issues that arose during the NA Sprint last night (a fun contest,
> BTW):
>
> I had a few QSO's where the frequency was logged as 14063M or 14063G, and
> marked as 'B'. Had to modify that and Recalculate Score, so no big deal.
> But have no idea why this occurred. Using an ICOM 756Pro2, and have never
> had any trouble with the radio interface. When marked Bad, always had
> 14063x, regardless of actual frequency or band.
>
> I noticed the following scenario: that when I grabbed a call it would,
> correctly, enter previous Name and QTH. But dangerously, if I then
> re-grabbed a different call without making the QSO (the first one didn't
> come back to me), it would retain the original call's Name and QTH.
> Shouldn't I expect them to also be replaced?
>
> And finally, on just two occasions that I noticed, the Name and QTH did
not
> fill in automatically, even though I had worked the station earlier. May
> have been on a new band, but most of the times that was not a problem, and
> the program entered the data properly.
>
> Any thoughts?
>
> Pete, K2PS
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
|