WriteLog
[Top] [All Lists]

Re: [WriteLog] [RTTY] slow fsk speed

To: <k0bx@qsl.net>
Subject: Re: [WriteLog] [RTTY] slow fsk speed
From: "Jim Sharp" <jimsharp1@verizon.net>
Date: Fri, 30 Sep 2005 16:42:35 -0500
List-post: <mailto:writelog@contesting.com>
Joe,

Thanks for your reply.

I did check on the sliders and they were all the way to the left. Sliding to 
the right does in fact slow down the rtty output rate. But when mine is all 
the way to the left, the output is still about 1/2 speed or so it seams 
(sounds in another receiver) . I also checked the bullet for "no TX wait"

I wish I could figure out how to load the "stand alone" mmtty version from 
Writelog - since with the extfsk module, the output is normal speed or rate. 
And interesting is if when running the stand alone MMTTY 1.65D with com(x) 
(for the TxD & Rts-ptt lines) selected instead of extfsk in the TX setup, 
the rtty output becomes slow again.  So EXTFSK works well, but I can not 
select it within Writelog with the bare bones mmtty that comes up. The 
writelog.ini shows the correct directory for mmtty (program files/mmtty)

Using another program - MixW - causes initially normal speed output but 
after several cq's the output becomes erratic using FSK. AFSK of course is 
normal.

I've had the same problems using a USB device - rigexpert, but I think the 
rigblaster plus works somewhat better.

Again, tnx for your input.

73, Jim

----- Original Message ----- 
From: <jduerbusch@charter.net>
To: <WriteLog@contesting.com>
Cc: <rtty@contesting.com>
Sent: Friday, September 30, 2005 12:32 PM
Subject: [WriteLog] [RTTY] slow fsk speed


> No one has mentioned this so I will:
>
> In MMTTY in WriteLog you are using the plug-in and it may not have the 
> same setup as the stand-alone version on your machine.
>
> What you want to check for, is to go to the MMTTY version while in WL. 
> right click and go to options on the MMTTY plugin.  Then to setup.
>
> Go to the TX menu tab and bring up the TX option screen.
> What you want to look for is the:
> "Char Wait" and "Diddle Wait" slide bar box.
> Make sure that the slide bar is all the way to the LEFT.  Moving it to the 
> right will cause the output character rate to slow down.  This was for 
> slow typest and was a feature on the UT-4B that was using with the ST-6.
>
> The other problem mentioned, the slow response going from TX to RCV is a 
> different problem which has happened to me many times, but don't remember 
> the fix.
>
> Anyway this may help?
>
> Joe K0BX
>
> Stop the insanity!
> Please do not add me to any distribution lists (Joke, Stories or Junk) 
> without my permission.
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/ 

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>