Thanks Roger for the feedback.
I have tried two different LPT interfaces and both do the same thing.
73-Bob
WA2MNO
> -----Original Message-----
> From: Roger Marrotte [mailto:marrotte@comcast.net]
> Sent: Saturday, December 09, 2006 6:42 PM
> To: 'Bob LaFont'
> Subject: RE: [WriteLog] CW Keying Hanging
>
> Bob,
>
> I had a similar problem a few years ago. I found a broken
> wire (the ground wire I think) in the cable connector. I had
> the interface circuit built into the connector. It worked
> sometimes and sometimes it wouldn't. I soldered the wire
> back on and it was rock solid after that.
>
> Roger, W1EM
>
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Bob LaFont
> Sent: Saturday, December 09, 2006 7:20 PM
> To: Writelog
> Subject: [WriteLog] CW Keying Hanging
>
> I am using WL 10.61e. CW keying is setup using LPT1.
>
> Periodically, CW keying hangs either during transmission or
> at the beginning of a transmission. It is not caused by RF in
> the shack as I have had the radio on a dummy load with
> minimal power out (less than 5 watts). I use Direct I/O for
> LPT keying as my system is XP.
>
> I have tried to find an answer in the archives and looked at
> the help files to find the answer but I could not find a
> solution there.
>
> Is this problem a possible corrupt file and if so are there
> any ideas on what this file would be and how to replace it
> that is the problem (complete
> uninstall/re-install) ?
>
>
> 73-Bob
> WA2MNO
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|