I have been using version 10.67 since I first put my (2) K3s on the air
using the K2 as the RIG in SETUP - PORTs. Just this morning, as there are
no contests this weekend that I will be participating in, I upgraded to
v10.68 that has the K3 listed in SETUP - PORTS. To my surprise it did not
work. NO RIG was displayed for both K3s. (I have Writelog setup for (2)
rigs with a DXDoubler for SO2R.) After a few failed attempts at
resolution I decided to manually set the baud selection to 4800. They now
work !!!
Question: Why does AUTO BAUD work fine in 10.67 and not in 10.68?
Is anyone else having this problem?
73,
Bruce - N1LN
(aka: NC4KW)
K3# 1062
K3# 1193
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|