Not sure if this problem is unique to the K3 driver or not. I've always
been under the impression that you should not use the AUTO setting and
manually set a baud rate to match the speed set up in the radio. I've got
my old IC-756PRO set to 19200 and it works great.
73,
Gary AL9A
----- Original Message -----
From: "Bruce Meier" <bemeier@bellsouth.net>
To: "'WriteLog'" <Writelog@contesting.com>
Sent: November 21, 2008 6:42 AM
Subject: [WriteLog] K3 question with v10.68
>I have been using version 10.67 since I first put my (2) K3s on the air
> using the K2 as the RIG in SETUP - PORTs. Just this morning, as there
> are
> no contests this weekend that I will be participating in, I upgraded to
> v10.68 that has the K3 listed in SETUP - PORTS. To my surprise it did not
> work. NO RIG was displayed for both K3s. (I have Writelog setup for (2)
> rigs with a DXDoubler for SO2R.) After a few failed attempts at
> resolution I decided to manually set the baud selection to 4800. They
> now
> work !!!
>
> Question: Why does AUTO BAUD work fine in 10.67 and not in 10.68?
>
> Is anyone else having this problem?
>
> 73,
> Bruce - N1LN
> (aka: NC4KW)
>
> K3# 1062
> K3# 1193
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|